PARKING BRAKE SYSTEM > ADJUSTMENT |
| 1. INSPECT PARKING BRAKE LEVER TRAVEL |
Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.
| 2. ADJUST PARKING BRAKE LEVER TRAVEL |
Remove the rear console box (Click here).
![]() |
Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.
![]() | Expand |
![]() |
Hold the automatic adjust lever away from the adjuster, and contract the brake shoe by turning the adjust bolt using another screwdriver until the drum can rotate smoothly.
![]() | Contract |
Check that there is no brake drag against the shoe.
![]() |
Turn the lock nut until the parking brake lever travel is corrected to within the specified range.
| *1 | Lock nut |
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
Install the rear console box (Click here).
| 3. INSPECT BRAKE WARNING LIGHT |
When operating the parking brake lever, check that the brake warning light illuminates.