Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1551    IG Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

The power steering ECU assembly distinguishes the ignition switch status as ON or off through the IG power source circuit.

DTC No.
DTC Detection Condition
Trouble Area
C1551
Open or short in IG power source circuit with ignition switch ON.
  1. ECU-IG NO. 1 fuse
  2. IG power source circuit
  3. Power steering ECU assembly

WIRING DIAGRAM


C240045E01


INSPECTION PROCEDURE

NOTICE:
  1. If the power steering ECU assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING INTELLIGENT TESTER (IG POWER SUPPLY)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item IG Power Supply in the Data List and read the value displayed on the tester.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG Power Supply
    ECU power source voltage/
    Min.: 0.0000 V
    Max.: 20.1531 V
    11 to 14 V
    Ignition switch is ON



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - IG CIRCUIT AND BODY GROUND)


    C233849E01
  1. Disconnect the power steering ECU assembly connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F6-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A42-2 (PGND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to Power Steering ECU Assembly)
    Result 
    Result
    Proceed to
    NG
    A
    OK (for LHD)
    B
    OK (for RHD)
    C



B
REPLACE POWER STEERING ECU ASSEMBLY (Click here)

C
REPLACE POWER STEERING ECU ASSEMBLY (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR