DTC C1552 PIG Power Supply Voltage Malfunction |
DTC C1554 Power Supply Relay Failure |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1552 | PIG power source circuit malfunction |
|
| C1554 | Power source relay circuit malfunction |
|

| 1.READ VALUE USING INTELLIGENT TESTER (PIG POWER SUPPLY) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Chassis / EMPS / Data List.
Select the item PIG Power Supply in the Data List and read the value displayed on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| PIG Power Supply | Power source voltage to activate motor/ Min.: 0.0000 V Max.: 20.1531 V | 11 to 14 V | The engine is running and power steering is operating |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the power steering ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A42-1 (PIG) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A42-2 (PGND) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to Power Steering ECU Assembly) |
| Result | Proceed to |
| NG | A |
| OK (for LHD) | B |
| OK (for RHD) | C |
|
| ||||
|
| ||||
| A | ||
| ||