INTEGRATION RELAY > INSPECTION |
| 1. INSPECT NO. 1 INTEGRATION RELAY |
Check the EFI MAIN relay.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1E-4 | Battery voltage not applied between 1E-10 - 1D-7 terminals | 10 kΩ or higher |
| Battery voltage applied between 1E-10 - 1D-7 terminals | Below 1 Ω |
| *a | Component without harness connected (No. 1 Integration Relay) |
Check the C/OPN relay.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1E-4 - 1E-5 | Battery voltage not applied between 1E-11 - 1D-9 terminals | 10 kΩ or higher |
| Battery voltage applied between 1E-11 - 1D-9 terminals | Below 1 Ω |
| *a | Component without harness connected (No. 1 Integration Relay) |
Check the IG2 relay.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1D-9 | Battery voltage not applied between 1E-10 - 1D-17 terminals | 10 kΩ or higher |
| Battery voltage applied between 1E-10 - 1D-17 terminals | Below 1 Ω |
| *a | Component without harness connected (No. 1 Integration Relay) |
Check the HORN relay.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1E-7 | Battery voltage not applied between 1C-1 - 1D-18 terminals | 10 kΩ or higher |
| Battery voltage applied between 1C-1 - 1D-18 terminals | Below 1 Ω |
| *a | Component without harness connected (No. 1 Integration Relay) |