Home › Engine / Hybrid System · 2NZ-FE › ENGINE CONTROL › INTEGRATION RELAY

INTEGRATION RELAY > INSPECTION

for Preparation Click here



1. INSPECT NO. 1 INTEGRATION RELAY


  1. Check the EFI MAIN relay.



      A244954E02
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1C-1 - 1E-4
      Battery voltage not applied between 1E-10 - 1D-7 terminals
      10 kΩ or higher
      Battery voltage applied between 1E-10 - 1D-7 terminals
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (No. 1 Integration Relay)
      If the result is not as specified, replace the EFI MAIN relay.



  1. Check the C/OPN relay.



      A244954E02
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1E-4 - 1E-5
      Battery voltage not applied between 1E-11 - 1D-9 terminals
      10 kΩ or higher
      Battery voltage applied between 1E-11 - 1D-9 terminals
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (No. 1 Integration Relay)
      If the result is not as specified, replace the C/OPN relay.



  1. Check the IG2 relay.



      A244954E02
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1C-1 - 1D-9
      Battery voltage not applied between 1E-10 - 1D-17 terminals
      10 kΩ or higher
      Battery voltage applied between 1E-10 - 1D-17 terminals
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (No. 1 Integration Relay)
      If the result is not as specified, replace the IG2 relay.



  1. Check the HORN relay.



      A244954E02
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1C-1 - 1E-7
      Battery voltage not applied between 1C-1 - 1D-18 terminals
      10 kΩ or higher
      Battery voltage applied between 1C-1 - 1D-18 terminals
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (No. 1 Integration Relay)
      If the result is not as specified, replace the HORN relay.