Home › Engine / Hybrid System · 2NZ-FE › ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT POSITION SENSOR


A105341E15
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    Camshaft Position Sensor)

    Standard Resistance:
    Tester Connection
    Condition
    Resistance
    1 - 2
    Cold
    1630 to 2740 Ω
    Hot
    2065 to 3225 Ω

    HINT:
    In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50 °C (14 to 122 °F). Hot means approximately 50 to 100 °C (122 to 212 °F).

    If the resistance is not as specified, replace the camshaft position sensor.