Home › Engine / Hybrid System · 1NZ-FE › ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CRANKSHAFT POSITION SENSOR


A064983E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Cold
    985 to 1600 Ω
    Hot
    1265 to 1890 Ω

    HINT:
    In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50 °C (14 to 122 °F). Hot means approximately 50 to 100 °C (122 to 212 °F).

    If the resistance is not as specified, replace the crankshaft position sensor.
    Text in Illustration 
    *a
    Component without harness connected
    (Crankshaft Position Sensor)