DRIVE BELT > INSTALLATION |
| 1. INSTALL FAN AND GENERATOR V BELT |
Provisionally install the fan and generator V belt onto each pulley.
| 2. ADJUST FAN AND GENERATOR V BELT |
![]() |
Insert an adjusting bar between the engine mounting bracket and generator assembly. Pull the adjusting bar toward the vehicle front to adjust the generator V belt tension.
| *a | OK |
| *b | NG |
![]() | Front of Vehicle |
![]() |
First tighten bolt A, then tighten bolt B.
| 3. INSPECT FAN AND GENERATOR V BELT |
![]() |
Check the fan and generator V belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the fan and generator V belt.
![]() |
Check that the fan and generator V belt fits properly in the ribbed grooves.
| *a | Correct |
| *b | Incorrect |
![]() |
Inspect the V belt deflection and tension.
| *A | w/o Air Conditioner |
| *B | w/ Air Conditioner |
| Item | Specified Condition | |
| New belt | 8.0 to 9.0 mm (0.31 to 0.35 in) | |
| Used belt | 12.5 to 13.5 mm (0.49 to 0.53 in) | |
| Item | Specified Condition | |
| New belt | 700 to 800 N (71 to 82 kg, 157 to 180 lb) | |
| Used belt | 300 to 400 N (31 to 41 kg, 67 to 90 lb) | |
| 4. INSTALL ENGINE UNDER COVER RH (for Plastic Type) |
| 5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type) |