OIL PUMP > INSPECTION |
| 1. INSPECT OIL PUMP RELIEF VALVE |
![]() |
Coat the oil pump relief valve with engine oil and check that it falls smoothly into the valve hole by its own weight.
If not, replace the oil pump relief valve. If necessary, replace the oil pump assembly.
| 2. INSPECT OIL PUMP ROTOR SET |
![]() |
Install the 2 rotors with both of the marks facing the oil pump cover side.
| *a | Mark |
![]() |
Check the rotor tip clearance.
Using a feeler gauge, measure the clearance between the drive and driven rotor tips.
![]() |
Check the rotor body clearance.
Using a feeler gauge, measure the clearance between the driven rotor and the oil pump body.