ENGINE UNIT > INSPECTION |
| 1. INSPECT CHAIN SUB-ASSEMBLY |
![]() |
Using a spring scale, apply 140 N (14.3 kgf, 31.5 lb) to the timing chain and measure its length.
| *a | Measuring Area |
| 2. INSPECT NO. 1 CHAIN TENSIONER ASSEMBLY |
![]() |
Check that the plunger moves smoothly when the ratchet pawl is raised with your finger.
Release the ratchet pawl and check that the plunger is locked in place by the ratchet pawl and does not move when pushed with your finger.
| 3. INSPECT CAMSHAFT TIMING GEAR ASSEMBLY |
![]() |
Wrap the chain around the camshaft timing gear.
Using a vernier caliper, measure the diameter of the camshaft timing gear with the chain.
| 4. INSPECT CAMSHAFT TIMING SPROCKET |
![]() |
Wrap the chain around the camshaft timing sprocket.
Using a vernier caliper, measure the diameter of the camshaft timing sprocket with the chain.
| 5. INSPECT CHAIN TENSIONER SLIPPER |
![]() |
Using a vernier caliper, measure the chain tensioner slipper wear.
| 6. INSPECT NO. 1 CHAIN VIBRATION DAMPER |
![]() |
Using a vernier caliper, measure the No. 1 chain vibration damper wear.
| 7. INSPECT CYLINDER HEAD SET BOLT |
![]() |
Using a vernier caliper, measure the length of the cylinder head set bolt from the seat to the end.
| *a | Measurement Length |