CYLINDER HEAD > DISASSEMBLY |
| 1. REMOVE NO. 1 WITH HEAD TAPER SCREW PLUG |
![]() |
Using a 10 mm socket hexagon wrench, remove the No. 1 with head taper screw plug and the gasket.
| 2. REMOVE VALVE LIFTER |
Remove the 16 valve lifters from the cylinder head.
| 3. REMOVE NO. 2 WITH HEAD TAPER SCREW PLUG |
![]() |
Using an 8 mm socket hexagon wrench, remove the No. 2 with head taper screw plug and the gasket.
| 4. REMOVE OIL CONTROL VALVE FILTER |
| 5. REMOVE INTAKE VALVE |
![]() |
Using SST, compress and remove the valve retainer locks.
Remove the retainer, valve spring and valve.
| 6. REMOVE EXHAUST VALVE |
Using SST, compress and remove the valve retainer locks.
Remove the retainer, valve spring and valve.
| 7. REMOVE VALVE STEM OIL SEAL |
![]() |
Using needle-nose pliers, remove the oil seal.
| 8. REMOVE VALVE SPRING SEAT |
![]() |
Using compressed air and Magnet Hand, remove the valve spring seats by blowing air onto them.
| 9. REMOVE STUD BOLT |
| 10. REMOVE CAMSHAFT BEARING CAP SETTING RING PIN |