Home › Engine / Hybrid System ยท 2NZ-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 1 WITH HEAD TAPER SCREW PLUG


    A062890E01
  1. Using a 10 mm socket hexagon wrench, remove the No. 1 with head taper screw plug and the gasket.



2. REMOVE VALVE LIFTER
  1. Remove the 16 valve lifters from the cylinder head.

    HINT:
    Keep the valve lifters in the correct order so that they can be returned to their original locations when reassembled.



3. REMOVE NO. 2 WITH HEAD TAPER SCREW PLUG


    A038128E01
  1. Using an 8 mm socket hexagon wrench, remove the No. 2 with head taper screw plug and the gasket.



4. REMOVE OIL CONTROL VALVE FILTER


5. REMOVE INTAKE VALVE


    A037109E03
  1. Using SST, compress and remove the valve retainer locks.

    SST
    09202-70020   (09202-00010)

    HINT:
    Arrange the removed parts in the correct order.

  1. Remove the retainer, valve spring and valve.

    HINT:
    Arrange the removed parts in the correct order.



6. REMOVE EXHAUST VALVE
  1. Using SST, compress and remove the valve retainer locks.

    SST
    09202-70020   (09202-00010)

    HINT:
    Arrange the removed parts in the correct order.

  1. Remove the retainer, valve spring and valve.

    HINT:
    Arrange the removed parts in the correct order.



7. REMOVE VALVE STEM OIL SEAL


    A080961E01
  1. Using needle-nose pliers, remove the oil seal.



8. REMOVE VALVE SPRING SEAT


    A080962E01
  1. Using compressed air and Magnet Hand, remove the valve spring seats by blowing air onto them.



9. REMOVE STUD BOLT


10. REMOVE CAMSHAFT BEARING CAP SETTING RING PIN