Home › Engine / Hybrid System ยท 2NZ-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > REASSEMBLY

for Preparation Click here



1. INSTALL CAMSHAFT BEARING CAP SETTING RING PIN


    A251013E01
  1. Using a plastic-faced hammer, tap a new ring pin in to the specified protrusion height.

    Protrusion height:
    4.5 to 5.5 mm (0.177 to 0.217 in.)



2. INSTALL STUD BOLT


  1. Using "TORX" socket wrenches E5 and E7, install the 11 stud bolts.


    A154874E02

    Torque:
    Bolt A, C:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }
    Bolt B:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }
    Bolt D:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



3. INSTALL VALVE STEM OIL SEAL


A050182E06
  1. Apply a light coat of engine oil to the valve stem oil seal.
    Text in Illustration 
    *a
    Intake
    *b
    Exhaust
    *c
    Gray
    *d
    Black

    NOTICE:
    Installing the oil seal for intake and exhaust onto the opposite valve guide bush may cause failures.

    HINT:
    The intake valve oil seal is gray and the exhaust valve oil seal is black.



    A001063E02
  1. Using SST, push in a new oil seal.

    SST
    09201-41020  



4. INSTALL INTAKE VALVE


A090736
  1. Install the valve, spring seat, valve spring, and spring retainer.

    NOTICE:
    Install the parts into their original locations in the original order.



    A037109E03
  1. Using SST, compress the spring and install the 2 retainer locks.

    SST
    09202-70020   (09202-00010)



    A090737E01
  1. Using a pin-punch (5 mm) and the valve stem (not in use) with its tip wrapped in tape, gently tap the valve stem tip to ensure a proper fit.

    NOTICE:
    Do not damage the valve stem tip.



5. INSTALL EXHAUST VALVE
  1. Install the valve, spring seat, valve spring, and spring retainer.

  1. Using SST, compress the spring and install the 2 retainer locks.

    SST
    09202-70020   (09202-00010)

  1. Using a pin-punch (5 mm) and the valve stem (not in use) with the tip wrapped in tape, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    Do not damage the valve stem tip.



6. INSTALL OIL CONTROL VALVE FILTER


    A050664E11
  1. Install the oil control valve filter.
    Text in Illustration 
    *1
    Oil Control Valve Filter



7. INSTALL NO. 2 WITH HEAD TAPER SCREW PLUG


A038128E01
  1. Using an 8 mm socket hexagon wrench, install the No. 2 with head taper screw plug and a new gasket.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }



8. INSTALL NO. 1 WITH HEAD TAPER SCREW PLUG


A062890E01
  1. Using a 14 mm socket hexagon wrench, install the No. 1 with head taper screw plug and a new gasket.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }