WATER PUMP > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN COOLANT |
![]() |
| *1 | Water Filler Cap Sub-assembly |
| *2 | Radiator Drain Cock Plug |
| *3 | Cylinder Block Drain Cock Plug |
Loosen the radiator drain cock plug.
Remove the water filler cap sub-assembly.
Loosen the cylinder block drain cock plug, then drain the coolant.
| 3. REMOVE ENGINE UNDER COVER RH |
![]() |
Remove the 3 screws, 2 bolts and the engine under cover RH.
| 4. REMOVE FAN AND GENERATOR V BELT |
![]() |
Loosen bolts A and B.
Release the fan and generator V belt tension and remove the fan and generator V belt.
| 5. REMOVE GENERATOR ASSEMBLY |
![]() |
Remove the terminal cap.
Disconnect the connector and the harness clamp.
Remove the nut and disconnect the wire harness from terminal B.
| *1 | Terminal B |
![]() |
Remove the belt adjusting slider fixing bolt A, nut B and the belt adjusting slider.
![]() |
Remove the bolt A, screw B and the piping clamp.
![]() |
Remove the fixing bolt and the generator assembly.
| 6. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
![]() |
Place a wooden block on a jack underneath the engine.
![]() |
Remove the 4 bolts, 2 nuts and the engine mounting insulator sub-assembly RH.
| 7. REMOVE WATER PUMP PULLEY |
![]() |
Using SST, hold the water pump pulley.
Remove the 3 bolts and the water pump pulley.
| 8. REMOVE WATER PUMP ASSEMBLY |
![]() |
Remove the 3 bolts and 2 nuts and remove the water pump assembly and water pump gasket.