Home › Engine / Hybrid System ยท 1NZ-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. DRAIN COOLANT


A264221E01

NOTICE:
To avoid the danger of being burned, do not remove the water filler cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot coolant and steam to blow out from the radiator assembly.

Text in Illustration 
*1
Water Filler Cap Sub-assembly
*2
Radiator Drain Cock Plug
*3
Cylinder Block Drain Cock Plug
  1. Loosen the radiator drain cock plug.

  1. Remove the water filler cap sub-assembly.

  1. Loosen the cylinder block drain cock plug, then drain the coolant.



2. SEPARATE WATER INLET


A116186
  1. Remove the 2 nuts and separate the water inlet with radiator hose from the cylinder block.



3. REMOVE THERMOSTAT


A116187
  1. Remove the thermostat from the cylinder block.

  1. Remove the gasket from the thermostat.