Home › Engine / Hybrid System ยท 1NZ-FE › ENGINE MECHANICAL › ENGINE UNIT

ENGINE UNIT > INSTALLATION

for Preparation Click here



1. INSTALL WIRE HARNESS CLAMP BRACKET


    A107284E01
  1. Install the 2 wire harness clamp brackets with the 2 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL BOOSTER VACUUM TUBE
  1. Install the booster vacuum tube with the 2 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



3. INSTALL NO. 1 WATER BY-PASS PIPE
  1. Install the No. 1 water by-pass pipe through a new gasket with the 2 bolts and 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



4. INSTALL GENERATOR ASSEMBLY


A244006
  1. Temporarily install the generator assembly with the fixing bolt.



    A247897E01
  1. Install the piping clamp with the bolt A and screw B.

    Torque:
    Bolt A:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



    A244005E01
  1. Temporarily install the fan belt adjusting slider with fan belt adjusting slider fixing bolt A and nut B.

  1. Move generator assembly toward the cylinder block and tighten nut B.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

  1. Connect the connector and engage the clamp.

  1. Install the wire harness to terminal B with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Install the terminal cap.