ENGINE UNIT > REMOVAL |
| 1. REMOVE GENERATOR ASSEMBLY |
![]() |
Remove the terminal cap.
Disconnect the connector and the harness clamp.
Remove the nut and disconnect the wire harness from terminal B.
| *1 | Terminal B |
![]() |
Remove the belt adjusting slider fixing bolt A, nut B and the belt adjusting slider.
![]() |
Remove the bolt A, screw B and the piping clamp.
![]() |
Remove the fixing bolt and the generator assembly.
| 2. REMOVE NO. 1 WATER BY-PASS PIPE |
![]() |
Remove the 2 bolts, 2 nuts and the No. 1 water bypass pipe.
| 3. REMOVE BOOSTER VACUUM TUBE |
![]() |
Remove the 2 bolts and the booster vacuum tube.
| 4. REMOVE WIRE HARNESS CLAMP BRACKET |
![]() |
Remove the 2 bolts and the 2 wire harness clamp brackets.