Home › Engine / Hybrid System ยท 2NZ-FE › LUBRICATION › OIL AND OIL FILTER

OIL AND OIL FILTER > REPLACEMENT

for Preparation Click here


CAUTION:
  1. Prolonged and repeated contact with engine oil will result in the removal of natural oils from the skin, leading to dryness, irritation and dermatitis. Used engine oil contains potentially harmful contaminants which may cause skin cancer.
  2. Take precautions when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Wear protective clothing and gloves that cannot be penetrated by oil. Wash skin with soap and water, or use waterless hand cleaner, to completely remove any used engine oil. Do not use gasoline, thinner, or solvents.
  3. Dispose of used oil and used oil filters at designated disposal sites in order to preserve the environment.



1. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil pan drain plug and drain the engine oil.

  1. Clean the drain plug.

  1. Install the drain plug with a new gasket.

    Torque:
    38 N*m{ 382 kgf*cm , 28 ft.*lbf }



2. REMOVE OIL FILTER SUB-ASSEMBLY


    A248714E02
  1. Using SST, remove the oil filter.

    SST
    09228-06501  



3. INSTALL OIL FILTER SUB-ASSEMBLY
  1. Clean the oil filter installation surface.

  1. Apply engine oil to the oil filter gasket.

  1. Lightly screw the oil filter into the engine until the oil filter does not turn.



    A248715E01
  1. Using SST, tighten the oil filter an additional 3/4 turn.

    SST
    09228-06501  

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



4. ADD ENGINE OIL
  1. Add fresh engine oil.

    Standard Oil Grade:

    Oil Grade
    Oil Viscosity (SAE)
    API grade SL "energy-conserving", API grade SM "energy-conserving" or ILSAC multigrade engine oil
    1. 5W-30
    1. 10W-30
    API grade SL or SM multigrade engine oil
    1. 15W-40
    1. 20W-50


    Oil capacity:

    Item
    Capacity
    Drain and refill with oil filter change
    3.7 liters (3.9 US qts, 3.3 Imp. qts)
    Drain and refill without oil filter change
    3.4 liters (3.6 US qts, 3.0 Imp. qts)
    Dry fill
    4.1 liters (4.3 US qts, 3.6 Imp. qts)



5. INSPECT FOR ENGINE OIL LEAK


6. CHECK ENGINE OIL LEVEL
  1. Warm up and stop the engine, and then wait for 5 minutes.

  1. Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill with engine oil above the full level mark.