Home › Engine / Hybrid System · 2NZ-FE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY


    A154756E05
  1. Check the resistance.
    Text in Illustration 
    *1
    Ohmmeter
    *a
    Component without harness connected
    (Fuel Injector Assembly)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      11.6 to 12.4 Ω

      If the result is not as specified, replace the injector assembly.



  1. Check the operation.

    CAUTION:
    Perform the inspection in a well-ventilated area.
    Do not perform the inspection near any open flames.




      A147389E07
    1. Connect SST (fuel tube connector) to SST (hose), and then connect them to the fuel pipe (vehicle side).
      Text in Illustration 
      *1
      Fuel Pipe
      *2
      SST (Clip)
      *3
      SST (Fuel Tube Connector)
      *4
      SST (Hose)

      SST
      09268-31013   (90467-13001, 95336-08070, 09268-41500)



    2. A129474E17
    3. Install the new O-ring onto the fuel injector.
      Text in Illustration 
      *1
      SST (Clip)
      *2
      SST (Adapter)
      *3
      SST (Hose)
      *4
      O-Ring
      *5
      SST (Clamp)
      *6
      Vinyl Tube

      SST
      09268-31013   (90467-13001, 95336-08070, 09268-41300, 09268-41110)

    4. Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).

    5. Put the injector into a graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector assembly to prevent gasoline splashes.

    6. Operate the fuel pump (Click here).



    7. A075915E22
    8. Connect SST (wire) to the injector assembly and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

      SST
      09842-30080  

      Injection Volume:
      Tester Connection
      Condition
      Specified Condition
      Positive terminal - Ground terminal
      Per 15 seconds
      47 to 58 cm3 (2.9 to 3.5 cu in.)

      Text in Illustration 
      *1
      SST (Wire)
      V100135
      Connect

      Difference between each injector:
      11 cm3 (0.7 cu in.) or less

      CAUTION:
      Always do the switching at the battery side.

      If the injection volume is not as specified, replace the injector assembly.



    A198105
  1. Check for leaks.

    1. In the condition above, disconnect the test probes of SST (wire) from the battery and check if the fuel leaks from the injector.

      Fuel Drop:
      1 drop or less every 12 minutes