BACK DOOR > ADJUSTMENT |

| *1 | Centering Bolt |
| *2 | Standard Bolt |
| 1. INSPECT BACK DOOR |
Check that the clearance measurements are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 6.0 to 9.0 mm (0.236 to 0.354 in.) | I | 3.0 to 8.0 mm (0.118 to 0.314 in.) |
| B | -0.5 to 2.5 mm (0.0196 to 0.0984 in.) | J | 4.0 to 6.0 mm (0.157 to 0.236 in.) |
| C | 6.0 to 9.0 mm (0.236 to 0.354 in.) | K | -1.5 to 1.5 mm (-0.0590 to 0.0590 in.) |
| D | -0.2 to 2.8 mm (0.00787 to 0.110 in.) | L | 3.2 to 7.2 mm 0.125 to 0.283 in.) |
| E | 4.1 to 7.1 mm (0.161 to 0.279 in.) | M | 3.2 to 7.2 mm (0.125 to 0.283 in.) |
| F | 1.3 to 4.3 mm (0.0511 to 0.169 in.) | N | 3.4 to 7.4 mm (0.133 to 0.291 in.) |
| G | 4.5 to 7.5 mm (0.177 to 0.295 in.) | O | 3.8 to 7.8 mm (0.149 to 0.307 in.) |
| H | -1.0 to 2.0 mm (-0.0393 to 0.0787 in.) | - | - |
| 2. REMOVE DECK BOARD ASSEMBLY |
![]() |
Remove the deck board.
| 3. REMOVE SPARE WHEEL COVER |
![]() |
Remove the spare wheel cover.
| 4. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Disengage the 4 claws and 4 guides and remove the rear floor finish plate.
| 5. ADJUST BACK DOOR |
![]() |
Adjust the door position.
Horizontally and vertically adjust the door by loosening the door side hinge bolts.
![]() |
Adjust the striker position.
Using a "TORX" socket wrench T40, adjust the striker position by slightly loosening the striker mounting bolts and hitting the striker with a plastic hammer.
Using a "TORX" socket wrench T40, tighten the striker mounting bolts after the adjustment.
| 6. INSTALL REAR FLOOR FINISH PLATE |
Engage the 4 guides and the 4 claws to install the rear floor finish plate.
| 7. INSTALL SPARE WHEEL COVER |
Install the spare wheel cover.
| 8. INSTALL DECK BOARD ASSEMBLY |
Install the deck board.