Home › Power Source / Network ยท 1NZ-FE BATTERY / CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY


A193553E02
  1. Clamp the generator housing stay in a vise tightly.

  1. Hold SST1-A with a torque wrench, and tighten SST1-B clockwise to the specified torque.

    SST
    09820-63011   (09820-06010, 09820-06021)

    Torque:
    64 N*m{ 653 kgf*cm , 47 ft.*lbf }

    Text in Illustration  
    *a
    Hold
    *b
    Turn

    NOTICE:
    Check that SST is securely fitted onto the generator rotor shaft.



    A193554E02
  1. Insert SST2, and engage SST2 to the generator pulley nut.



    A193555E02
  1. To loosen the generator pulley nut, turn SST1-A in the direction shown in the illustration.
    Text in Illustration  
    *a
    Hold
    *b
    Turn

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the generator pulley nut by more than one half turn.

  1. Remove SST2 from the generator assembly.



    A193556E04
  1. Hold SST1-A, turn SST1-B, and remove SST1-A and SST1-B in the direction shown in the illustration.
    Text in Illustration  
    *a
    Hold
    *b
    Turn

  1. Remove the generator pulley nut and generator pulley.

  1. Remove the generator assembly from a vise.



2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


A245754
  1. Remove the nut and generator terminal insulator.



    A206812E02
  1. Remove the nut A, screw and rectifier plate.
    Text in Illustration 
    *1
    Rectifier Plate

  1. Remove the 2 nuts B, and the generator rear end cover.



    A117359E01
  1. Remove the generator brush cover.

  1. Remove the 3 screws and the generator brush holder assembly.

  1. Remove the generator plate seal.
    Text in Illustration 
    *1
    Generator Brush Cover
    *2
    Generator Brush Holder Assembly
    *3
    Generator Plate Seal



3. REMOVE GENERATOR REGULATOR ASSEMBLY


A219752
  1. Remove the 2 screws and generator regulator assembly.



4. REMOVE GENERATOR HOLDER WITH RECTIFIER


A219753
  1. Remove the 3 screws and generator holder with rectifier.



5. REMOVE GENERATOR ROTOR ASSEMBLY


A183136E02
  1. Remove the 3 terminal insulators from the generator rectifier end frame.

  1. Remove the 3 nuts A, nut B and cord clip.
    Text in Illustration  
    *1
    Terminal Insulator
    *2
    Cord Clip



    A234485E01
  1. Using SST, remove the generator rectifier end frame.

    SST
    09286-46011  
    Text in Illustration  
    *1
    Wooden Block
    *a
    Hold
    *b
    Turn



    A247898
  1. Remove the generator washer from the generator rotor assembly.



    A182584E02
  1. Using a plastic hammer, remove the generator rotor assembly from the generator drive end frame assembly.
    Text in Illustration 
    *1
    Wooden Block
    *2
    Plastic Hammer

    NOTICE:
    Do not drop the generator rotor assembly.

    HINT:
    If the generator rotor assembly is engaged too firmly, gentry tap the generator shaft to remove it using a plastic hammer.