CLUTCH RELEASE CYLINDER > INSTALLATION |
| 1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY |
Install the clutch release cylinder assembly with the 2 bolts.
| 2. CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE |
Using a union nut wrench (10 mm), connect the clutch release cylinder to flexible hose tube to the clutch release cylinder assembly.
| 3. FILL RESERVOIR WITH BRAKE FLUID |
![]() |
Fill the reservoir with brake fluid.
| *A | for LHD |
| *B | for RHD |
| *a | MAX Line |
| *b | MIN Line |
| 4. BLEED CLUTCH LINE |
![]() |
Remove the release cylinder bleeder plug cap.
| *1 | Release Cylinder Bleeder Plug Cap |
| *2 | Release Cylinder Bleeder Plug |
Connect a vinyl tube to the release cylinder bleeder plug.
Depress the clutch pedal 5 times, and then loosen the release cylinder bleeder plug while the pedal is depressed.
When fluid no longer comes out, tighten the release cylinder bleeder plug, and then release the clutch pedal.
Repeat both of the previous 2 steps 6 times.
Tighten the release cylinder bleeder plug.
Depress the clutch pedal 10 times or more and confirm its operation.
Install the release cylinder bleeder plug cap.
Check that all the air has been bled from the clutch line.
| 5. INSPECT FOR BRAKE FLUID LEAK |
| 6. INSPECT BRAKE FLUID LEVEL |
![]() |
Check the fluid level.
| *A | for LHD |
| *B | for RHD |
| *a | MAX Line |
| *b | MIN Line |