Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR WINDOW FRAME MOULDING (for Rear Side)

FRONT DOOR WINDOW FRAME MOULDING (for Rear Side) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE FRONT DOOR WINDOW FRAME REAR MOULDING
  1. Using an infrared light, heat the front door window frame rear moulding.

    CAUTION:
    Do not burn yourself with the heated front door panel or infrared light.

    NOTICE:
    Remove any tape remaining on the front door panel.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.



    B283009E02
  1. Pull up the front door window frame rear moulding, disengage the 2 clips while peeling off the double-sided adhesive tape, and remove the front door window frame rear moulding.
    Text in Illustration 
    *1
    Double-sided tape