DIFFERENTIAL CASE > DISASSEMBLY |
| 1. REMOVE FRONT DRIVE PINION REAR TAPERED ROLLER BEARING |
![]() |
Using SST and a press, remove the front drive pinion rear tapered roller bearing (inner race) and the counter driven gear from the differential drive pinion.
![]() |
Using SST, remove the front drive pinion rear tapered roller bearing (outer race) and the drive pinion washer from the transaxle case.
| 2. REMOVE FRONT DRIVE PINION FRONT TAPERED ROLLER BEARING |
![]() |
Using SST and a press, remove the front drive pinion front tapered roller bearing (inner race) from the differential drive pinion.
![]() |
Using SST, remove the front drive pinion front tapered roller bearing (outer race) from the transaxle housing.
| 3. REMOVE DIFFERENTIAL DRIVE PINION PLUG |
![]() |
Using an extension bar and a hammer, remove the differential drive pinion plug.
| 4. REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case front tapered roller bearing (inner race) from the front differential case.
![]() |
Using SST, remove the front differential case front tapered roller bearing (outer race) from the transaxle housing.
| 5. REMOVE SPEEDOMETER DRIVE GEAR (w/o ABS) |
![]() |
Remove the speedometer drive gear from the front differential case.
| 6. REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case rear tapered roller bearing (inner race) from the front differential case.
![]() |
Using SST, remove the front differential case rear tapered roller bearing (outer race) and the front differential case rear plate washer from the transaxle case.
| 7. REMOVE FRONT DIFFERENTIAL RING GEAR |
![]() |
Place matchmarks on the front differential ring gear and the front differential case.
| *a | Matchmark |
![]() |
Remove the 8 bolts.
![]() |
Using a plastic hammer, remove the front differential ring gear from the front differential case.
| 8. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
![]() |
Using a punch and hammer, loosen the staked part of the front differential case.
![]() |
Using a pin punch 3 mm and hammer, remove the front differential pinion shaft straight pin from the front differential case.
| 9. REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT |
![]() |
Remove the front No. 1 differential pinion shaft from the front differential case.
| 10. REMOVE DIFFERENTIAL GEAR KIT |
![]() |
Remove the differential gear kit (2 front differential pinions and 2 front differential side gears), 2 front differential side gear thrust washers and the 2 front differential pinion thrust washers from the front differential case.