Home › Engine / Hybrid System ยท 1NZ-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > REPAIR

for Preparation Click here



1. REPAIR INTAKE VALVE


A067983E02
  1. Repair the intake valve seat.

    NOTICE:
    Releasing the seat-cutter pressure gradually helps to the make valve seat face smoother.

  1. If the seating is too high on the valve face, use 20° and 45° cutters to correct it.



    A080979E05
  1. If the seating is too low on the valve face, use 75° and 45° cutters to correct it.

  1. Hand-lap the valve and valve seat with an abrasive compound.

  1. Recheck the valve seating position.



2. REPAIR EXHAUST VALVE

NOTICE:
Releasing the seat-cutter pressure gradually helps to make the valve seat face smoother.

  1. If the seating is too high on the valve face, use 20° and 45° cutters to correct it.

  1. If the seating is too low on the valve face, use 75° and 45° cutters to correct it.

  1. Hand-lap the valve and valve seat with an abrasive compound.

  1. Recheck the valve seating position.