Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH

UNLOCK WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    B225713E05
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Lever
    *a
    Component without harness connected
    (Unlock Warning Switch Assembly)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (UN+) - 2 (UN-)
    Lever not pushed
    10 kΩ or higher
    Lever pushed
    Below 1 Ω

    If the result is not as specified, replace the unlock warning switch.