CHARGING SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK BATTERY CONDITION |
Check the battery for damage and deformation. If severe damage, deformation or leak is found, replace the battery.
Check the voltage.
Turn the ignition switch off and turn on the headlights for 20 to 30 seconds. This will remove the surface charge from the battery.
Measure the battery voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Positive(+) terminal - Negative(-) terminal | 20°C (68°F) | 12.5 to 12.9 V |
| 2. CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
If the terminals are corroded, clean them.
| 3. CHECK FUSES |
Measure the resistance of the fuses.
| 4. CHECK V-RIBBED BELT |
![]() |
Insert an adjusting bar between the engine mounting bracket and generator assembly. Pull the adjusting bar toward the vehicle front to adjust the generator V belt tension.
| *a | OK |
| *b | NG |
![]() | Front of Vehicle |
![]() |
First tighten bolt A, then tighten bolt B.
| 5. INSPECT GENERATOR WIRING |
Check that the wiring is in good condition.
| 6. LISTEN FOR ABNORMAL NOISE FROM GENERATOR |
Check that the generator does not emit any abnormal noise while the engine is running.
| 7. INSPECT CHARGE WARNING LIGHT CIRCUIT |
Turn the ignition switch to ON. Check that the charge warning light comes on.
Start the engine and check that the light turns off.
If the light does not operate as specified, troubleshoot the charge warning light circuit.
| 8. INSPECT CHARGING CIRCUIT WITHOUT LOAD |
![]() |
Connect a voltmeter and an ammeter to the charging circuit as follows.
Disconnect the wire from terminal B of the generator and connect it to the negative (-) lead of the ammeter.
| *1 | Ammeter |
| *2 | Terminal B |
| *3 | Battery |
| *4 | Voltmeter |
| *5 | Generator |
Connect the ammeter positive (+) lead to terminal B of the generator.
Connect the voltmeter positive (+) lead to terminal B of the battery.
Ground the voltmeter negative (-) lead.
Check the charging circuit.
Keep the engine speed at 2000 rpm and check the reading on the ammeter and voltmeter.
| 9. INSPECT CHARGING CIRCUIT WITH LOAD |
With the engine running at 2000 rpm, turn the high beam headlights on and turn the heater blower switch to the "HI" position.
Check the reading on the ammeter.