Home › Brake › BRAKE (REAR) › REAR BRAKE

REAR BRAKE > INSPECTION

for Preparation Click here



1. INSPECT REAR BRAKE DRUM INSIDE DIAMETER


    F006408E03
  1. Using a brake drum gauge or the equivalent, measure the inside diameter of the brake drum.
    Text in Illustration 
    *1
    Brake Drum Gauge

    Inside diameter:
    Standard
    Maximum
    200 mm (7.874 in.)
    201 mm (7.913 in.)

    If the inside diameter is greater than the maximum, replace the brake drum.



2. INSPECT REAR BRAKE SHOE LINING THICKNESS


    F042690E04
  1. Using a ruler, measure the thickness of the shoe lining.
    Text in Illustration 
    *1
    Ruler

    Thickness:
    Standard
    Minimum
    4.0 mm (0.157 in.)
    1.0 mm (0.039 in.)

    If the lining thickness is equal to or less than the minimum value, or if there is any severe or uneven wear, replace the brake shoe.

    NOTICE:
    If the brake shoes need replacing, they must be replaced as a set.



3. INSPECT REAR BRAKE DRUM AND REAR BRAKE SHOE LINING FOR PROPER CONTACT


    C151738
  1. Apply chalk to the inside surface of the drum, then grind the brake shoe lining so that they fit together properly.
    If the contact between the drum and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly.



4. INSPECT REAR WHEEL BRAKE CYLINDER
  1. Check the cylinder bore and piston for rust and scoring.