Home › Brake › BRAKE (REAR) › REAR BRAKE

REAR BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR BRAKE SHOE KIT


    C108968E01
  1. Using SST, separate the shoe return spring from the front brake shoe.

    SST
    09921-00011  

    NOTICE:
    Do not damage the wheel cylinder boot.



    C108969E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.

    SST
    09718-00011  

  1. Remove the tension spring.



    C108970
  1. Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.



    C108971E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.

    SST
    09718-00011  



    C108972
  1. Using needle-nose pliers, separate the parking brake cable.



2. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER


    C233135
  1. Remove the automatic adjust lever tension spring and the automatic adjust lever.



3. REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY


    C108973
  1. Using a screwdriver, remove the C-washer and parking brake shoe lever.



4. REMOVE REAR DRUM BRAKE BLEEDER PLUG CAP


5. REMOVE REAR DRUM BRAKE BLEEDER PLUG


6. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY


    C241887
  1. Using a union nut wrench 10 mm, separate the brake tube from the rear wheel brake cylinder.

    HINT:
    Use a container to catch the brake fluid.

  1. Remove the bolt and rear wheel brake cylinder.



7. REMOVE REAR WHEEL CYLINDER KIT


    C196579E01
  1. Remove the 2 wheel cylinder boots from the wheel brake cylinder.
    Text in Illustration 
    *1
    Wheel Cylinder Boot
    *2
    Wheel Cylinder Piston
    *3
    Wheel Cylinder Cup
    *4
    Compression Spring

  1. Remove the 2 pistons.

  1. Remove the wheel cylinder cup from each piston.

  1. Remove the compression spring.