Home › Brake › BRAKE (REAR) › REAR BRAKE

REAR BRAKE > REASSEMBLY

for Preparation Click here



1. INSTALL REAR WHEEL CYLINDER KIT


    C190260E02
  1. Apply lithium soap base glycol grease to 2 new wheel cylinder cups and the 2 pistons.
    Text in Illustration 
    *1
    Lithium Soap Base Glycol Grease

  1. Install the wheel cylinder cup onto each piston.

  1. Install the compression spring and 2 pistons onto the wheel brake cylinder.

  1. Install 2 new wheel cylinder boots onto the wheel brake cylinder.



2. INSTALL REAR WHEEL BRAKE CYLINDER ASSEMBLY
  1. Install the wheel brake cylinder with the bolt.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Using a union nut wrench 10 mm, install the brake tube.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



3. TEMPORARILY TIGHTEN REAR DRUM BRAKE BLEEDER PLUG


4. INSTALL REAR DRUM BRAKE BLEEDER PLUG CAP


5. INSTALL REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY
  1. Using needle-nose pliers, install the parking brake shoe lever with a new C-washer.



6. INSTALL REAR BRAKE AUTOMATIC ADJUST LEVER
  1. Install the automatic adjust lever and automatic adjust lever tension spring onto the front brake shoe.



7. INSTALL REAR BRAKE SHOE KIT


    C190261E02
  1. Apply high temperature grease to the surface of the backing plate which is in contact with the shoe.
    Text in Illustration 
    *1
    High Temperature Grease



    C108972
  1. Using needle-nose pliers, install the parking brake cable onto the parking brake shoe lever.



    C108971E01
  1. Using SST, install the rear brake shoe, pin, shoe hold down spring and shoe hold down spring cup.

    SST
    09718-00011  



    C179336E03
  1. Apply high temperature grease to the adjusting bolt.
    Text in Illustration 
    *1
    High Temperature Grease



    F040013E06
  1. Install the parking brake shoe strut set as shown in the illustration.
    Text in Illustration 
    *1
    Backing Plate
    *2
    Parking Brake Shoe Strut Set



    C108969E01
  1. Using SST, install the front brake shoe, pin, shoe hold down spring and shoe hold down spring cup.

    SST
    09718-00011  



    F042698
  1. Using needle-nose pliers, install the tension spring onto the front brake shoe and rear brake shoe.



    C108968E01
  1. Using SST, install the shoe return spring onto the front brake shoe.

    SST
    09921-00011  

    NOTICE:
    Do not damage the wheel cylinder boot.



8. CHECK REAR DRUM BRAKE INSTALLATION


  1. Check that each part is installed properly.


    C241885E01


    Text in Illustration 
    *a
    for LH Side
    *b
    for RH Side
    V100135
    Front of the Vehicle
    -
    -



    C116892
  1. Measure the brake drum inner diameter and the diameter of the brake shoes. Check that the difference between the diameters is equal to the specified shoe clearance.

    Shoe clearance:
    0.6 mm (0.024 in.)

    NOTICE:
    There should be no oil or grease adhering to the friction surfaces of the shoe lining or the drum.