SIDE AIRBAG SENSOR (for 3 Door) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
![]() |
Insert a clip remover between the plate and front door trim board.
Turn the handle with the clip remover inserted, as shown in the illustration.
Remove the front door window regulator handle and clip.
Remove the window regulator handle plate.
| 4. REMOVE FRONT ARMREST BASE UPPER PANEL (w/ Power Window) |
![]() |
Using a moulding remover, disengage the 9 claws and 4 guides.
Disconnect the connector and remove the front armrest base upper panel.
| 5. REMOVE FRONT ARMREST BASE UPPER PANEL (w/o Power Window) |
![]() |
Using a moulding remover, disengage the 6 claws and 3 guides.
Disconnect the connector.
| 6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.
| *1 | Protective Tape |
![]() |
Remove the 3 screws.
![]() |
Disengage the 8 clips.
![]() |
Disconnect the front door lock remote control cable and the front door inside locking cable and remove the front door trim board.
| *1 | Front Door Lock Remote Control Cable Assembly |
| *2 | Front Door Inside Locking Cable Assembly |
| 7. REMOVE DOOR SIDE AIRBAG SENSOR |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Disconnect the connector from the door side airbag sensor.
Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.

| *1 | Housing Lock | *2 | Outer Connector Locking Sleeve |
| *a | Slide | - | - |
Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.
![]() |
Remove the bolt and door side airbag sensor.