SIDE AIRBAG SENSOR (for 3 Door) > INSTALLATION |
| 1. INSTALL DOOR SIDE AIRBAG SENSOR |
Check that the ignition switch is off.
Confirm that the cable is disconnected from the battery negative (-) terminal.
Insert the pin (stopper) into the body hole and install the front airbag sensor with the bolt.
Connect the connector to the door side airbag sensor.
Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).

| *1 | Outer Connector Locking Sleeve | - | - |
| *a | Slide | - | - |
Check that there is no looseness in the installation parts of the door side airbag sensor.
| 2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Connect the front door lock remote control cable and the front door inside locking cable to the front door inside handle.
| *1 | Front Door Lock Remote Control Cable Assembly |
| *2 | Front Door Inside Locking Cable Assembly |
![]() |
Engage the 8 clips and the front door trim board.
![]() |
Install the 3 screws.
![]() |
Engage the claw and close the cover.
| 3. INSTALL FRONT ARMREST BASE UPPER PANEL (w/ Power Window) |
Connect the connector.
![]() |
Engage the 9 claws and 4 guides, and install the front armrest base upper panel.
| 4. INSTALL FRONT ARMREST BASE UPPER PANEL (w/o Power Window) |
Connect the connector.
![]() |
Engage the 6 claws and 3 guides, and install the front armrest base upper panel.
| 5. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
![]() |
Install the window regulator handle plate.
| *a | Inside of Vehicle |
Open all the windows.
![]() |
Install the front door window regulator handle with clip at the angle shown in the illustration.
| *a | Assemble with Glass in Fully Open Position |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. INSPECT SRS WARNING LIGHT |
| 8. INSPECT POWER WINDOW OPERATION |