Home › Drivetrain ยท AXLE AND DIFFERENTIAL › STEERING KNUCKLE

STEERING KNUCKLE > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side as for the LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT AXLE HUB BEARING


    C152371E01
  1. Using SST and a press, insert a new axle hub bearing, with its magnetic rotor side facing the inside of the vehicle, until it reaches the end of the steering knuckle.
    Text in Illustration 
    *a
    Magnetic Rotor Side
    V100135
    Inside of the vehicle

    SST
    09950-60020   (09951-00710)
    09950-70010   (09951-07100)

    NOTICE:
    1. Do not remove the inner race because the hub bearing is built into the oil seal.
    2. Do not use bearings that have been removed.
    3. Do not wipe off any grease that has been applied to new bearings.
    4. Do not bring magnets close to the magnetic rotor surface of the bearing.
    5. Keep the magnetic rotor surface of the bearing free of foreign matter.



2. INSTALL FRONT DISC BRAKE DUST COVER


    C243642E01
  1. Provisionally install a new disc brake dust cover, as shown in the illustration.

    Standard distance A:
    19.8 mm (0.78 in.)



    C243001E01
  1. Using SST and a hammer, install the disc brake dust cover.

    SST
    09223-56010  

    NOTICE:
    1. Uniformly press in the disc brake dust cover while sliding SST slightly.
    2. Press in the disc brake dust cover until it is securely seated to the pressing-in base.



    C107918
  1. Using a chisel, fix the 3 points on the circumference.

    NOTICE:
    Securely fold each end into the engagement grooves.



3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY


    C107983E01
  1. Using SST and a press, press the axle hub into the steering knuckle.

    SST
    09950-70010   (09951-07100)
    09950-60010   (09951-00580)
    09608-32010  



4. INSTALL FRONT AXLE HUB HOLE SNAP RING


    C202605E02
  1. Using snap ring pliers, install a new axle hub hole snap ring, as shown in the illustration.
    Text in Illustration 
    *1
    Snap Ring Pliers
    *a
    Speed Sensor Installation Gap

    NOTICE:
    1. Do not overlap the end of the snap ring and the installation hole in the speed sensor on the knuckle side.
    2. Do not damage the magnetic rotor surface of the bearing when installing the snap ring.



5. INSTALL FRONT AXLE ASSEMBLY
(Click here)