Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB

REAR AXLE HUB > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side as for the LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


3. SEPARATE SKID CONTROL SENSOR WIRE (w/ ABS)


    C107565
  1. Using a screwdriver, disengage the claw of the connector lock portion and disconnect the skid control sensor wire LH connector.

    NOTICE:
    Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.



    C107566
  1. Remove the nut and separate the skid control sensor wire LH.



4. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    C235100
  1. Remove the 4 bolts and remove the axle hub and bearing from the axle beam.