Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB

REAR AXLE HUB > ON-VEHICLE INSPECTION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side as for the LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


3. INSPECT REAR AXLE HUB BEARING BACKLASH


    C121815
  1. Using a dial indicator, check the backlash near the center of the axle hub.

    Maximum:
    0.05 mm (0.00197 in.)

    If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.



4. INSPECT REAR AXLE HUB RUNOUT


    C121816
  1. Using a dial indicator, check the runout of the surface of the axle hub.

    Maximum:
    0.07 mm (0.00276 in.)

    If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.



5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY


6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }