Home › Drivetrain ยท U441E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP

OIL PUMP > INSPECTION

for Preparation Click here



1. INSPECT STATOR SHAFT ASSEMBLY


C059806E01
  1. Using a caliper gauge, measure the inside diameter of the stator shaft bush.

    Standard inside diameter:
    18.424 to 18.449 mm (0.725 to 0.726 in.)

    Maximum inside diameter:
    18.449 mm (0.726 in.)

    If the inside diameter is greater than the maximum, replace the stator shaft assembly.



    C059990E01
  1. Install the input shaft assembly onto the stator shaft assembly, and check that the input shaft assembly turns smoothly.



2. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY


C081414E01
  1. Using a caliper gauge, measure the inside diameter of the front oil pump body bush.

    Standard inside diameter:
    38.113 to 38.138 mm (1.5005 to 1.5015 in.)

    Maximum inside diameter:
    38.138 mm (1.5015 in.)

    If the inside diameter is greater than the maximum, replace the front oil pump drive gear, front oil pump driven gear and the front oil pump body.



3. INSPECT OIL PUMP GEAR CLEARANCE


    C059809E01
  1. Check the tip clearance.
    Using a feeler gauge, measure the clearance between the tips of the front oil pump driven gear teeth and the front oil pump drive gear teeth.

    Standard tip clearance:
    0.07 to 0.15 mm (0.00276 to 0.00591 in.)

    Maximum tip clearance:
    0.15 mm (0.00591 in.)

    If the tip clearance is greater than the maximum, replace the front oil pump drive gear, front oil pump driven gear and the front oil pump body.



    C059810E01
  1. Check the body clearance.
    Using a feeler gauge, measure the clearance between the front oil pump driven gear and front oil pump body.

    Standard body clearance:
    0.10 to 0.17 mm (0.00394 to 0.00669 in.)

    Maximum body clearance:
    0.17 mm (0.00669 in.)

    If the body clearance is greater than the maximum, replace the front oil pump drive gear, front oil pump driven gear and the front oil pump body.



    C059811E01
  1. Check the side clearance.
    Using a steel straightedge and feeler gauge, measure the side clearance of both gears.

    Standard side clearance:
    0.02 to 0.05 mm (0.000787 to 0.00197 in.)

    Maximum side clearance:
    0.05 mm (0.00197 in.)

    If the side clearance is greater than the maximum, replace the front oil pump drive gear, front oil pump driven gear and the front oil pump body.