Home › Engine / Hybrid System ยท CRUISE CONTROL › CLUTCH SWITCH

CLUTCH SWITCH > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL NO. 2 CLUTCH START SWITCH ASSEMBLY
  1. Install the No. 2 clutch start switch assembly with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

  1. Connect the connector.



2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B287816E01
  1. Connect the airbag connector.
    Text in Illustration 
    *1
    Locking Button

  1. Push in the locking button.

    NOTICE:
    Securely lock the locking button.

  1. Engage the 6 claws and install the lower No. 1 instrument panel airbag assembly.

  1. Install the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)
  1. for LHD:

    1. Engage the 5 claws and 2 clips and install the instrument panel finish panel.

  1. for RHD:

    1. Engage the 6 claws and 2 clips and install the instrument panel finish panel.



4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Engage the guide and the claw.

  1. Install the instrument panel under cover with the 2 <A> screws.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. INSPECT SRS WARNING LIGHT
(Click here)