FRONT WIPER MOTOR > REMOVAL |
| 1. REMOVE FRONT WIPER ARM HEAD CAP |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the front wiper arm head cap.
| *1 | Protective Tape |
| 2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY |
![]() |
Disconnect the washer hose.
![]() |
Remove the nut and the front wiper main arm.
| *1 | Front Wiper Main Arm |
![]() |
Remove the front wiper sub arm and the front wiper arm and blade as shown in the illustration.
| *a | Head of the Front Wiper Sub Arm |
| *b | Joint Section on the End of the Front Wiper Arm |
| 3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH |
![]() |
Peel off the double - sided tape and disengage the claw and guide.
| *1 | Double - sided Tape |
Disengage the clip and claw and remove the front fender to cowl side seal.
| 4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH |
| 5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY |
![]() |
Disconnect the washer hose.
Disengage the 2 clamps.
![]() |
Remove the 2 clips.
Disengage the 5 claws and 3 guides.
Disengage the 9 guides and remove the cowl top ventilator louver.
| 6. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |
![]() |
Remove the 2 bolts.
Disengage the grommet and remove the windshield wiper motor and link as shown in the illustration.
Disconnect the connector.
| 7. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the windshield wiper link rod from the crank arm pivot of the windshield wiper motor as shown in the illustration.
| *1 | Protective Tape |
| *a | Windshield Wiper Link Rod |
| *b | Crank Arm Pivot of the Windshield Wiper Motor Assembly |
![]() |
Using a T30 "TORX" socket wrench, remove the 2 bolts and the windshield wiper motor from the windshield wiper link.