Home › General › SPECIFICATIONS › 1NZ-FE BATTERY / CHARGING

1NZ-FE BATTERY / CHARGING > SERVICE DATA



Generator brush holder assembly brush exposed length
Standard exposed length
9.5 to 11.5 mm (0.374 to 0.453 in.)
Minimum exposed length
4.5mm (0.177 in.)
Generator rotor assembly resistance
Slip ring - Slip ring
1.7 to 2.1 Ω at 20°C (68°F)
Slip ring - Rotor
10 MΩ or higher
Generator rotor assembly slip ring diameter
Standard diameter
14.2 to 14.4 mm (0.559 to 0.567 in.)
Minimum diameter
14.0 mm (0.551 in.)
Generator drive end frame assembly resistance
Coil lead - Coil lead
Below 1Ω
Coil lead - Generator drive end frame assembly
10 kΩ or higher
Generator holder with rectifier resistance
P1, P2, P3 - B
Resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction.
P1, P2, P3 - E
Resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction.
Generator regulator assembly resistance
Terminals F - Terminals B
When the positive and negative poles between terminals F and B are exchanged, there is a resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction.
Terminals E - Terminals F
When the positive and negative poles between terminals E and F are exchanged, there is a resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction.