DTC B2784 Antenna Coil Open / Short |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2784 | The antenna coil built into the transponder key amplifier is open or shorted (determined by communication with transponder key ECU assembly) (1 trip detection logic*).
|
| Insert the key into the ignition key cylinder. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Engine cannot be started | - |
| DTC Code | Data List and Active Test |
| B2784 | Antenna Coil Status |
| 1.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK TRANSPONDER KEY AMPLIFIER (OUTPUT) |
![]() |
Using an oscilloscope, check the waveform.
Waveform (Reference)
| Item | Content |
| Tester Connection | F55-4 (CODE) - F55-7 (AGND) |
| Tool Setting | 1 V/DIV., 100 μs./DIV. |
| Condition | Key inserted in ignition key cylinder |
| *a | Component with harness connected (Transponder Key Amplifier) |
| *b | Waveform |
|
| ||||
| OK | |
| 4.REPLACE TRANSPONDER KEY ECU ASSEMBLY |
Replace the transponder key ECU assembly (Refer to Service Bulletin).
| NEXT | |
| 5.REGISTER KEY |
Reregister the key (Refer to Service Bulletin).
| NEXT | |
| 6.REGISTER ECU COMMUNICATION ID |
Register the ECU communication ID (Refer to Service Bulletin).
| NEXT | |
| 7.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 8.CHECK FOR DTC |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||