1NZ-FE SFI SYSTEM > PRECAUTION | |
- NOTICE:
- If the ECM is replaced, register the ECU communication ID for Immobiliser System (refer to the registration procedures for Service Bulletin).
- Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (Click here).
- Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle body components .
- Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM .
| 2.USING INTELLIGENT TESTER |
- CAUTION:
Observe the following items for safety reasons:
- Read the intelligent tester instruction books before using the tester.
- Make sure that the tester cable is not caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
- When driving the vehicle for testing purposes while using the tester, 2 persons are required. One person drives the vehicle and the other operates the tester.