Home › Engine / Hybrid System ยท 2NZ-FE › ENGINE CONTROL › SFI SYSTEM

SFI SYSTEM > PRECAUTION

for Preparation Click here



1.INITIALIZATION

NOTICE:
  1. If the ECM is replaced, register the ECU communication ID for Immobiliser System (refer to the registration procedures for Service Bulletin).
  1. Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (Click here).
  2. Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle body components .
  3. Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM .


2.USING INTELLIGENT TESTER

CAUTION:
Observe the following items for safety reasons:
  1. Read the intelligent tester instruction books before using the tester.
  2. Make sure that the tester cable is not caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
  3. When driving the vehicle for testing purposes while using the tester, 2 persons are required. One person drives the vehicle and the other operates the tester.