FRONT SEAT ASSEMBLY (for Front Passenger Side) > INSTALLATION |
| 1. INSTALL FRONT SEAT ASSEMBLY |
![]() |
Insert the 2 location pins through the 2 body holes to temporarily install the front seat assembly, place the front seat in the foremost position and make sure that the inner and outer seat tracks are locked securely.
Using an E10 "TORX" socket wrench, install bolt 1 and then bolt 2 onto the rear side.
Move the front seat to the rearmost position, and then make sure that the inner and outer seat tracks are securely locked.
Using an E10 "TORX" socket wrench, install bolt 3 and then bolt 4 onto the front side.
Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.
Connect the buckle switch connector. (w/ Wire Harness)
Connect the front seat side airbag connector. (w/ Front Seat Side Airbag)
| 2. INSTALL SEAT TRACK OUTER COVER |
Move the seat to the foremost position.
Engage the 2 claws to install the seat track outer cover.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag) |
| 4. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag) |