FRONT SEAT ASSEMBLY (for Front Passenger Side) > DISASSEMBLY |
| 1. REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/ Wire Harness) |
![]() |
Disconnect the occupant detection sensor connector.
Remove the 6 clamps.
![]() |
Disengage the clamp.
Remove the bolt and the front seat inner belt assembly.
| 2. REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/o Wire Harness) |
![]() |
Remove the bolt and the front seat inner belt assembly.
| 3. REMOVE FRONT SEAT HEADREST ASSEMBLY |
Remove the front seat headrest assembly.
| 4. REMOVE RECLINING ADJUSTER RELEASE HANDLE |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw to remove the reclining adjuster release handle.
| *1 | Protective Tape |
| 5. REMOVE FRONT SEAT CUSHION SHIELD |
![]() |
Remove the screw.
Disengage the 2 claws and clip, and remove the front seat cushion shield.
| 6. REMOVE FRONT SEAT CUSHION INNER SHIELD |
![]() |
Disengage the 2 claws to remove the front seat cushion inner shield.
| 7. REMOVE SEAT CUSHION COVER WITH PAD |
![]() |
Disconnect the seatback cover band.
![]() |
Unfasten the hook and loop fastener. (w/ Front Seat Side Airbag)
![]() |
Disengage the 4 hooks.
![]() |
Disengage the 7 clamps to separate the front seat side airbag wire harness. (w/ Front Seat Side Airbag)
![]() |
Disengage the guide to remove the occupant detection sensor connector. (w/ Occupant Detection Sensor)
![]() |
Disengage the 2 hooks.
Disengage the 5 hooks and remove the seat cushion cover with pad.

| 8. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER |
![]() |
Remove the 2 hog rings.
![]() |
Remove the 14 hog rings and the separate type front seat cushion cover from the separate type front seat cushion pad.
| 9. REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY (for 3 Door) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and 2 guide to remove the reclining remote control lever cover.
| *1 | Protective Tape |
![]() |
Remove the 2 screws.
![]() |
Disengage the clamp and cable end and remove the reclining remote control lever sub-assembly.
| 10. REMOVE SEATBACK COVER WITH PAD |
![]() |
Remove the 3 hog rings.
![]() |
Remove the 3 hog rings.
![]() |
Unfasten the 2 zippers. (for Sport Package)
![]() |
Disengage the 4 claws to remove the 2 front seat headrest supports.
![]() |
Remove the 2 nuts and the seatback bracket. (w/ Front Seat Side Airbag)
Remove the front seatback cover with pad.
| 11. REMOVE SEPARATE TYPE FRONT SEATBACK COVER |
![]() |
Remove the 6 hog rings and the separate type front seatback cover from the separate type front seatback pad.
| 12. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Front Seat Side Airbag) |
![]() |
Disengage the 2 clamps.
![]() |
Remove the 2 nuts and the front seat side airbag assembly.
| 13. REMOVE RECLINING REMOTE CONTROL BASE (for 3 Door) |
![]() |
Disengage the 4 guides to remove the reclining remote control base.
| 14. REMOVE RECLINING ADJUSTER INSIDE COVER RH |
![]() |
Disengage the guide to remove the reclining adjuster inside cover RH.
| 15. REMOVE RECLINING ADJUSTER INSIDE COVER LH |
![]() |
Disengage the guide to remove the reclining adjuster inside cover LH.
| 16. REMOVE SEAT CUSHION EDGE PROTECTOR RH |
![]() |
Remove the screw.
Disengage the 2 guides to remove the seat cushion edge protector RH.
| 17. REMOVE SEAT CUSHION EDGE PROTECTOR LH |
![]() |
Remove the screw.
Disengage the 2 guides to remove the seat cushion edge protector LH.
| 18. REMOVE RECLINING ADJUSTER EQUALIZING CABLE ASSEMBLY (for 3 Door) |
![]() |
Separate the casing cap.
| *1 | Casing cap |
Disengage the nipple end and clamp to remove the reclining adjuster equalizing cable assembly.
| 19. REMOVE RECLINING REMOTE CONTROL CABLE ASSEMBLY (for 3 Door) |
![]() |
Disengage the 3 clamps and cable end to remove the reclining remote control cable assembly.
| 20. REMOVE SEAT LOCK CONTROL CABLE ASSEMBLY (for 3 Door) |
![]() |
Disengage the 2 clamps and 2 cable end to remove the seat lock control cable assembly.
| 21. REMOVE SEPARATE TYPE FRONT SEATBACK SPRING ASSEMBLY |
![]() |
Remove the 4 bolts and separate type front seatback spring assembly.
| 22. REMOVE SEAT ADJUSTER COVER CAP |
![]() |
Remove the 2 seat adjuster cover caps.
| 23. REMOVE SEAT TRACK ADJUSTING HANDLE |
![]() |
Disengage the 2 hooks to remove the seat track adjusting handle from the separate type front seat cushion spring assembly.