Home › Vehicle Interior › LIGHTING (INT) › PERSONAL LIGHT

PERSONAL LIGHT > INSPECTION

for Preparation Click here



1. INSPECT MAP LIGHT ASSEMBLY


    E222168E01
  1. Apply battery voltage to the connector and check the map light comes on.
    Text in Illustration 
    *a
    Component without harness connected
    (Map Light Assembly)

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+) → 3
    Battery negative (-) → 1
    All Switch off
    All light not comes on
    Battery positive (+) → 3
    Battery negative (-) → 2
    All Switch off
    All light not comes on
    Battery positive (+) → 3
    Battery negative (-) → 1
    Center Switch off
    LH Side Switch on
    LH Side light comes on
    Battery positive (+) → 3
    Battery negative (-) → 1
    Center Switch off
    RH Side Switch on
    RH Side light comes on
    Battery positive (+) → 3
    Battery negative (-) → 1
    LH Side Switch off
    RH Side Switch off
    Center Switch on
    All light comes on
    Battery positive (+) → 3
    Battery negative (-) → 2
    LH Side Switch off
    RH Side Switch off
    Center Switch DOOR
    All light comes on

    If the result is not as specified, replace the map light blub or map light assembly.