CRUISE CONTROL MAIN SWITCH > INSPECTION |
| 1. INSPECT CRUISE CONTROL MAIN SWITCH |

Measure the resistance and check the results in accordance with the value(s) in the table below.
| *a | Component without harness connected (Cruise Control Main Switch) | *b | Cruise Control Main Switch |
| *c | Lever | *d | ON/OFF |
| *e | -SET | *f | +RES |
| *g | CANCEL | - | - |
| Tester Connection | Switch Condition | Specified Condition |
| 1(ECC) - 3(CCS) | Main Switch off*1 | 1 MΩ or higher |
| Main Switch on | Below 2.5 Ω | |
| +RES | 235 to 245 Ω | |
| -SET | 617 to 643 Ω | |
| CANCEL | 1509 to 1571 Ω |