Home › Engine / Hybrid System · CRUISE CONTROL › CLUTCH SWITCH

CLUTCH SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH SWITCH ASSEMBLY


D011485E34
  1. Check the resistance between the terminals when the switch is ON and OFF.
    Text in Illustration 
    *a
    Component without harness connected
    (No. 2 clutch start switch assembly)
    *b
    7.65 to 8.35 mm (0.301 to 0.329 in.)

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    OFF (released)
    10 kΩ or higher
    ON (pushed in)
    Below 1 Ω

    If the result is not as specified, replace the No. 2 clutch start switch assembly.