SHIFT LEVER > INSTALLATION |
| 1. INSTALL SHIFT LEVER ASSEMBLY |
Install the shift lever assembly with the 4 bolts.
Engage the 3 clamps and install the wire harness to the shift lever assembly.
Connect the 2 connectors to the shift lever assembly.
| 2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Rotate the nut of the transmission control cable assembly counterclockwise 180° and push in the lock while holding the nut.
| *1 | Nut |
| *2 | Lock |
![]() |
Install the outer part of the transmission control cable assembly to the shift lever retainer.
| *1 | Lock |
| *2 | Shift Lever Retainer |
![]() |
Confirm that the shift lever is in N and connect the end of the transmission control cable assembly to the shift lever assembly.
| 3. ADJUST SHIFT LEVER POSITION |
Move the shift lever to N.
![]() |
Slide the adjuster case cover in the direction shown by the arrow.
| *1 | Adjuster Case |
| *2 | Cover |
| *3 | Lock Piece |
Using a precision screwdriver, pull up the lock piece.
![]() |
Press the lock piece into the adjuster case.
| *1 | Adjuster Case |
| *2 | Lock Piece |
| *3 | Cable Rod |
| *4 | Cover |
Slide the adjuster case cover in the direction shown by the arrow.
| 4. INSPECT SHIFT LEVER POSITION |
Turn the ignition switch to ON and step on the brake pedal.
Confirm that the shift lever moves smoothly through all of the shift positions and the position indicator shows the correct shift lever position.
Start the engine and confirm that the vehicle moves forward when the shift lever is moved from N to D.
| 5. INSTALL REAR CONSOLE BOX ASSEMBLY |
| 6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Turn the shift lever knob clockwise and install the shift lever knob sub-assembly to the shift lever assembly.
| *1 | Knob Cover |