Home › Drivetrain ยท U441E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > REMOVAL

for Preparation Click here



1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    C244552
  1. Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly from the shift lever assembly.



2. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


3. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Move the shift lever to N.



    C244554
  1. Disconnect the end of the transmission control cable assembly from the shift lever assembly.



    C244556E01
  1. Rotate the nut counterclockwise approximately 180°, and while supporting the nut, separate the transmission control cable assembly from the shift lever retainer.
    Text in Illustration 
    *1
    Nut

    NOTICE:
    Do not rotate the nut excessively. If the nut is rotated too far, the internal spring will be damaged and the transmission control cable assembly will be unusable.



4. REMOVE SHIFT LEVER ASSEMBLY


    C244562
  1. Disconnect the 2 connectors from the shift lever assembly.

  1. Disengage the 3 clamps and separate the wire harness from the shift lever assembly.



    C244560
  1. Remove the 4 bolts and the shift lever assembly.