AIR CONDITIONING UNIT > DISASSEMBLY |
| 1. REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Remove the 2 screws and the air conditioning radiator damper servo.
| 2. REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Remove the 2 screws and the air conditioning radiator damper servo.
| 3. REMOVE DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the defroster damper control cable.
| *1 | Protective Tape |
| 4. REMOVE AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System) |
![]() |
Remove the plate.
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the air mix damper control cable.
| *1 | Protective Tape |
| 5. REMOVE ASPIRATOR PIPE (for Automatic Air Conditioning System) |
![]() |
Disengage the 2 claws and remove the aspirator pipe.
| 6. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() |
Disengage the 3 claws and remove the clamp.
![]() |
Remove the heater radiator unit from the air conditioner radiator.
| 7. REMOVE COOLER EXPANSION VALVE |
![]() |
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and detach the cooler expansion valve.
Remove the 2 O-rings from the cooler evaporator.
| 8. REMOVE DRAIN COOLER HOSE |
![]() |
Remove the drain cooler hose.
| 9. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Disengage the clamp and remove the connector from the lower heater case.
![]() |
Remove the 3 screws.
Disengage the 4 claws and remove the lower heater case.
![]() |
Remove the cooler evaporator with the cooler thermistor.
| 10. REMOVE NO. 1 COOLER THERMISTOR |
![]() |
Remove the front evaporator temperature sensor (No. 1 cooler thermistor).